Blog

Why Do Drum Motors Fail in Washdown? (Thermal Breathing Explained)

Drum motors fail in washdown mainly because of thermal breathing. Their internal gears and oil generate heat during production, then cold washdown water cools the drum quickly and the pressure drop draws moisture past the seals. Over time that water mixes with the oil and attacks bearings and windings. PulleyDrive avoids this by having no gears and no oil inside.

Will Salley, 2 minute read

why do drum motors fail; drum motor thermal breathing; drum motor water ingress; drum motor oil leak food; drum motor alternative

What is thermal breathing in a drum motor?

A drum motor is a sealed tube with a motor, a gearbox and an oil bath inside. When it runs, the gears churn the oil and everything heats up. The air inside expands. When the line stops for sanitation, cold water hits a hot drum. The air contracts, the internal pressure drops below atmospheric, and the drum sucks in whatever is around the seal. In a washdown room, that is water and cleaning chemicals. 

One cycle does almost nothing. Two cycles a day for months is a different story. 

Why can’t better seals fix it?

Seals slow the problem down. They do not remove the cause. As long as there is a gearbox inside the drum making heat and an oil bath that expands and contracts, the pressure swing will keep working on the seal lips. Engineers have been improving drum motor seals for decades, and the failure mode is still the number one complaint we hear. 

How is PulleyDrive designed differently?

PulleyDrive by One Motion is an outrunner, high torque permanent magnet direct drive. The magnets sit on the rotating shell and the torque is made right where the belt is. There is no gearbox inside and no oil. With no gear stage churning oil, there is far less internal heat to drive the pressure swing that causes breathing, and nothing inside for water to contaminate. 

Because it is direct drive, you also get constant torque across the speed range and instant start and stop response, which most geared drum motors cannot match. 

Traditional Drum Motors 


Motor, gearbox, oil bath


 Gear friction and oil churning 


High Thermal breathing risk


Oil above product 


Limited by gear ratio 


One Motion™ PulleyDrive 


Permanent magnet, no oil 


Motor losses only 


Designed out 


Oil-free 


Wide range, constant torque 


What should you check on your current drum motors?

  • Milky or foamy oil during service. 

  • Weeping at the shaft seals after sanitation. 

  • Failures clustered a few weeks after a change in cleaning chemicals or procedure. 

  • Drum shells running noticeably warm to the touch before washdown. 

Frequently asked questions

Is PulleyDrive a drop-in drum motor replacement?

PulleyDrive is offered in standard diameters and face widths with sprockets matched to your belt, so it can replace a drum motor in most conveyor frames. Configure yours at pulleydrive.app (opens in a new tab). 

Does PulleyDrive need oil changes?

No. There is no oil inside. 

Is PulleyDrive IP69K?

Yes, it is a sealed stainless design built for high-pressure washdown. 

If drum motor failures are a recurring headache, configure a PulleyDrive at pulleydrive.app (opens in a new tab).

Found this useful? Share it with your team.

Have a line to solve?

Tell us about your application. Our engineers will help you find the right motion, whether it’s a drop-in drive or a custom design.