Blog

Do You Need Servos for Product Spacing and High-Speed Merges?

For most food processing merges, spacing and phasing jobs, you do not need servos. One Motion Multi-Drive and powered side belts use direct drive with standard VFDs, a PLC and photo-eyes to merge lanes, correct skew and control gaps. In real installations this approach doubled throughput, for example bagged product from 100 to 200 per minute.

Will Salley, 2 minute read

Top-down view of two lanes of bagged product merging into one evenly spaced stream over a One Motion Multi-Drive with two independent faces. Motion blur on product, sharp drive.   |  Two-to-one high-speed conveyor merge using One Motion Multi-Drive without servos

Why do merges usually get so complicated?

A traditional merge stacks belts, washdown servo motors, stainless gearboxes, servo drives and a lot of cabling, all to get products from two lanes into one evenly spaced stream. Every added layer is another thing to clean, tune and maintain. 

How does direct drive get servo-like accuracy in open loop?

The method is familiar to any controls engineer. You set up a virtual axis at 360 degrees per revolution, calculate the revolutions per second you need from your target rate, and convert that to frequency. When a product passes the photo-eye, you capture the virtual axis position, compare it to your setpoint, and adjust the speed. 

The difference is the hardware. With no gearbox and no backlash between the motor and the belt, the speed correction reaches the product immediately and the same way every time. That consistency is what lets a standard VFD do work that normally gets specified as a servo axis. 

What is a Multi-Drive?

A Multi-Drive mounts several One Motion direct drives side by side on one shaft with minimal gap between them. Each face runs at its own speed and direction. Assemblies range from two drives up to more than 30. One compact unit can merge lanes, correct skew by running one side slightly faster than the other, and control gaps at speed. 

Do you sell the whole merge machine?

No, and that is deliberate. We help OEMs and end users build their own systems with our direct drive technology and know-how. You bring the conveyor design. We bring the drives, PLC framework code to coordinate the product streams, programming support at no additional cost, and our GUS AI support agent for setup and troubleshooting. 

Other applications using the same approach

  • Spacing product for delta robot pick and place. 

  • Phasing product into cleated conveyors. 

  • Flow wrapper infeeds. 

  • Chicaning and lane alignment with oil-free side belts running 0 to 514 rpm. 

  • Collators, including a servo-less bag collator. 

Frequently asked questions

Can a VFD really replace a servo for product spacing?

For most food spacing, merging and phasing tasks, yes, when paired with a direct drive that has no gear backlash. Applications needing tight absolute positioning can run the same motor on a servo-class drive. 

How many drives can go on one shaft?

From two up to more than 30 independent drives. 

Is the PLC code free?

Yes. We provide the framework and help program it at no additional cost. 

Planning a merge or infeed? Bring us the layout at onemotion.tech.

Found this useful? Share it with your team.

Have a line to solve?

Tell us about your application. Our engineers will help you find the right motion, whether it’s a drop-in drive or a custom design.